Tekla Structures
Tekla Structure Issue: Assembly to multi sheet issue
Ok until I up graded to ver 16 all was fine. WhenI put six beam on a multi sheet. I will get 3 on one sheet and 3 on the next. The layouts are all the same that I have been using. No changes. One odd thing is on columns I will put 2 on a sheet and get differnt results. Some times I will get one per sheets, sometimes 2 one under the other. Then sometimes it will do it correct. 2 on a sheet side by side.
On beams somtimes it will put them in postion 1 postion 2 postions 3 postions 4 and then it will put beam 5 to the right of beam 4.
In the past I was able to take 100 or more same size layouts at one time and get 6 per sheet.
Enter the forum for further discussion about this issue.
Tekla Structure Issue: Assembly to multi sheet issue
Ok until I up graded to ver 16 all was fine. WhenI put six beam on a multi sheet. I will get 3 on one sheet and 3 on the next. The layouts are all the same that I have been using. No changes. One odd thing is on columns I will put 2 on a sheet and get differnt results. Some times I will get one per sheets, sometimes 2 one under the other. Then sometimes it will do it correct. 2 on a sheet side by side.
On beams somtimes it will put them in postion 1 postion 2 postions 3 postions 4 and then it will put beam 5 to the right of beam 4.
In the past I was able to take 100 or more same size layouts at one time and get 6 per sheet.
Enter the forum for further discussion about this issue.